LUT-HQP7-1
The HomeWorks QSX processor provides control and communication to HomeWorks system components.
The HomeWorks QSX processor provides control and communication to HomeWorks system components. The Ethernet links allow communication to the HomeWorks designer software, integration with third party systems and communication between multiple processors.
HomeWorks QSX processors may be connected using either an Ethernet hub /switch or router, or by using Ethernet directly from a PC to the processors.
Clear Connect – Type X Gateways cannot be wired directly to the Ethernet port on a HomeWorks QSX processor.
All processors on a project must be connected to a single network.
The HomeWorks designer software and all integration equipment must be connected to the same network as the processors.
This processor is required when using the Clear Connect Type X Gateway for control of residential Ketra light sources.
The processor is powered from the QSPS-DH-1-75-H power supply. This processor can be installed in a HQ-LV21, L-LV21, L-LV14, or PDx control panel
FEATURES
SPECIFICATIONS
| Power | Processor (P): 24–36 V – 250 mA Links (L1 / L2): 24–36 V – 2 A per link |
| Typical Power | 4.2 W; 8 Power Draw Units (PDUs) |
| Consumption | Test conditions: Two Ethernet links connected, both device links in use |
| Regulatory Approvals | cULus, NOM, CE |
| Environment | Indoor use only. 0°C / 32 °F to 40°C / 104°F 0% to 90% humidity, non condensing |
| Heat Generated | 15 BTU/hr typical (24 BTU/hr with 2 links at 2 A each output) |
| Cooling Method | Passive cooling |
| Power Failure Memory | System data stored in non volatile memory Timeclock retention for 10 years |
| Internal Timeclock | ±1 minute per year |
| Mis-wire Protection | All terminal block inputs are over-voltage and mis-wire protected against wire reversals and shorts |
| Low Voltage Link Wire Type | Two pair One pair 18 AWG (0.75mm 2), one pair 18 to 22 AWG (0.34 to 0.75mm 2) twisted shielded — IEC PELV / NEC® Class 2 cable |
| Low Voltage Power Wire Type | 18 AWG (0.75mm 2) |
| Communications | Ethernet, RS485 (QS, RF) |
| Link Capacities | HomeWorks QS Wired Device Link 99 devices/512 zones HomeWorks QS Wired Device (MDU models) 50 devices/50 zones HomeWorks Clear Connect – Type A Link 99 devices/100 zones |
| ESD Protection | Meets or exceeds the IEC 61000-4-2 standard |
| Surge Protection | Meets or exceeds ANSI/IEEE C62.41 standard |
| Mounting | Mounts in HQ-LV21, L-LV14, L-LV21, or PDx- control panel |
| Dimensions | With terminal blocks: 108mm / 4.25″ x 100mm / 3.94″ Without terminal blocks: 108mm / 4.25″ x 90mm / 3.54″ |
| Connections | 4 pin removable terminal blocks. 1 for HQP7-1, 2 for HQP7-2. One 4 pin removable terminal block* for Power Input Two RJ45 standard Ethernet connections *Each terminal will accept up to two 18 AWG (0.75 mm 2) wires. |
We use cookies to improve your experience on our site. By continuing to browse our site, you agree to the use of cookies. For more information, please see our privacy policy.
