LUTRON HOMEWORKS SWITCHING POWER MODULE – 5A

LUT-LQSE-4S5-230-D

Lutron HomeWorks 5A Switching Power Module is a 4 zone power module designed to control switching lighting loads. It includes QS link for seamless connection to a HomeWorks QS system.

Lutron HomeWorks 5A Switching Power Module is a 4 zone power module designed to control switching lighting loads.

It includes QS link for seamless connection to a HomeWorks QS system.

The adaptive zero cross switching technology maximises relay life expectancy.

It is rated for motor loads of 1/2 HP.

LEDs on the module provide diagnostic information and the buttons on module provide override control.

FEATURES

Rated for lighting loads as defined by IEC/EN 60669 as well as INC, MLV, and ELV
LEDs on the module provide diagnostic information
Buttons on the module provide override control
Manual Override Contact Closure Input (CCI)
Programmable Contact Closure Output (CCO)
Power failure memory automatically returns the outputs to the levels they were set to prior to a power outage

SPECIFICATIONS

Power	220 to 240V 50/60Hz Single input feed 16 A maximum total input current Lightning strike protection meets ANSI/IEEE standard C62.41 and IEC 61000-4-5 Can withstand voltage surges of up to 6 000V~ and current surges of up to 3 000A. ESD protected above agency requirements per IEC 60669-2-1 For ungrounded delta feed applications, contact Lutron
Regulatory Approvals	IEC/EN 60669 Lutron® Quality Systems registered to ISO 9001.2008 CE marked
Environment	Relative humidity: less than 90% non-condensing For indoor use only.
Output Zone Ratings	Each zone is rated at 5 A for switching. Rated for resistive, inductive or capacitive lighting loads as defined by IEC/EN 60669. Air gap off per output. No minimum load per output. This module is designed to control loads with ratings as noted in the table below. Outputs cannot be used to control general-purpose receptacles. Please consult the output Zone Rating section of the product specification sheet for further details under specific conditions.
Programming and Compatibility Requirements	Setup and programming of the Switching Module is done through the HomeWorks QS programming software. HomeWorks QS software version 12.0 or higher required.
QS Link Limits	A QS link in a HomeWorks QS system can have up to 512 zones (outputs) and 100 devices (required HomeWorks QS processor counts as 1 device on the QS link). Each Switching Module counts as one device toward the 100 device limit, and 4 zones toward the 512 zone limit.
Terminals	Torque – 0.6Nm (5in-lbs) Power terminals 1mm2 to 2.5mm2 (18AWG to 12 AWG) single wire, solid or stranded Data terminal 0.5mm2 to 2.5mm2 (22AWG to 12 AWG) single wire, solid or stranded 0.5mm2 to 1mm2 (20AWG to 18 AWG) two wires, solid or stranded
Mounting	Please consult the product specification sheet for mounting details.
Dimension	Height: 90mm / 3.54″ Width: 162mm / 6.38″ Depth: 61mm / 2.40″